I have an old Indicator developed for MT4, that I compiled in Jforex.
It's working all fine and one part of the code:
...
if(displayAlert)
Print("RU");//DisplayAlert("Reverse bullish divergence on: ", currentTrough);
...
This print shows the message on the 'Messages' tab.

Also developed, there is a Strategy Java for Jforex that I would like to "read" the message sent by the Indicator and proceed with the code.
Tried to use event onMessage and get the result, but couldn't find anyway to read.
Any idea if is that possible and how to?

Thanks in advance.

I think you can make a new array holding entry signal in your indicator source code.
This array would contains, BUY, SELL, NO_OPERATION.

Now in your strategy you can retrieve that signal, but first you need load the indicator manually.

https://www.dukascopy.com/wiki/#Use_custom_indicator_in_strategies

Hi popopo,
Saw that, but still facing the situation where the Indicator is an old development in MT4 (just compiled for JF) and would need to 're-write' if need to implement the new array entry value.
And this is what I'm trying to avoid (kinda complicated one)!

Anyway that can I get a 'non-standard' message (on Message tab) while on the onMessage event for a Strategy? Not sure how that would be.

Thx for your reply! I used that similar into another case

Rgds