User rating: 3
Joined: Mon 30 Aug, 2010, 13:06
Posts: 27
|
|
I just had the situation that the zigzag indicator drew a line from a high to the actual low. then the next candle made another low, but the zigzag didnt connect to the new low. The new low was not connected until the close of the candle. It should connect it as soon there is a new low / high made. I attached a picture of this happening. I would be happy if this could be fixed. Thank you!
best, simplex
| Attachments: |
zigzag.PNG [3.01 KiB]
Downloaded 458 times
|
|
DISCLAIMER: Dukascopy Bank SA's waiver of responsability - Documents, data or information available on
this webpage may be posted by third parties without Dukascopy Bank SA being obliged to make any control
on their content. Anyone accessing this webpage and downloading or otherwise making use of any document,
data or information found on this webpage shall do it on his/her own risks without any recourse against
Dukascopy Bank SA in relation thereto or for any consequences arising to him/her or any third party from
the use and/or reliance on any document, data or information found on this webpage.
|
|
|
