Dukascopy Support Board • View topic

fxbird

I am doing some semi-automated trading, so I am looking for a way to get, through the API, the Trade ID available in the JForex trade log.
I found only the Position ID with the IOrder.getID().

For a specific position (IOrder), I can get:
- the opening trade with getFillHistory()
- the trades used to partially close a position with getCloseHistory()

But how can I get the TradeID of these trades (as in the Jforex trade log)?
There was a similar question in the forum, but if I am not mistaken the replies didn't answer that specific point.

Thank you in advance

API Support

fxbird wrote:

But how can I get the TradeID of these trades (as in the Jforex trade log)?

This information is not available from API.

fxbird wrote:

Also, second question: why does the ICloseOrder date change over time without any new trade?

Could you provide more information about the case? What actions were done/attempted with the given position? Were there any disconnects around the changed close time?

fxbird

API Support wrote:

This information is not available from API.

Ok, thank you for the answer. I will find a workaround in my code.

fxbird wrote:

Also, second question: why does the ICloseOrder date change over time without any new trade?

API Support wrote:

Could you provide more information about the case? What actions were done/attempted with the given position? Were there any disconnects around the changed close time?

It's stange because after I got the ICloseOrder for that position a few other times, the date was correct (this is why I deleted that part from my post). I don't think there was any disconnect around that time.
If I see this behavior again, I will open a new post.

Thank you API support