|
Rounding |
pedion
|
Post subject: Rounding |
Post rating: 0
|
Posted: Mon 22 Aug, 2016, 11:44
|
|
User rating: 0
Joined: Mon 12 Jan, 2015, 16:12 Posts: 11 Location: United States, Virginia
|
Dear Support Team, Is there any rounding function in visual jforex? Thank you in advance, pedion
|
|
|
|
|
amine_chourou
|
Post subject: Re: Rounding |
Post rating: 0
|
Posted: Mon 29 Aug, 2016, 17:54
|
|
Visual JForex expert at Dukascopy | |
User rating: 288
Joined: Thu 18 Apr, 2013, 09:26 Posts: 1496 Location: Switzerland, Geneva
|
|
|
|
|
pedion
|
Post subject: Re: Rounding |
Post rating: 0
|
Posted: Fri 16 Dec, 2016, 14:36
|
|
User rating: 0
Joined: Mon 12 Jan, 2015, 16:12 Posts: 11 Location: United States, Virginia
|
Hello, Unfortunately I can't use it because I'd like to round trade amount. (I'd like to subtract 1000 from my "unrounded"/original amount again and again till the result will be equal or smaller than 1000 and finally subtract the remnant from the original amount, but don't know how to make the above mentioned cycle.) Regards, pedion
|
|
|
|
|
amine_chourou
|
Post subject: Re: Rounding |
Post rating: 0
|
Posted: Fri 16 Dec, 2016, 17:18
|
|
Visual JForex expert at Dukascopy | |
User rating: 288
Joined: Thu 18 Apr, 2013, 09:26 Posts: 1496 Location: Switzerland, Geneva
|
Hi !
I've made a workaround that might fit with your requirement. Attached ...
Attachments: |
rounding_workaround.vfs [29.75 KiB]
Downloaded 100 times
|
DISCLAIMER: Dukascopy Bank SA's waiver of responsability - Documents, data or information available on
this webpage may be posted by third parties without Dukascopy Bank SA being obliged to make any control
on their content. Anyone accessing this webpage and downloading or otherwise making use of any document,
data or information found on this webpage shall do it on his/her own risks without any recourse against
Dukascopy Bank SA in relation thereto or for any consequences arising to him/her or any third party from
the use and/or reliance on any document, data or information found on this webpage.
|
|
|
|
|
|
pedion
|
Post subject: Re: Rounding |
Post rating: 0
|
Posted: Mon 19 Dec, 2016, 07:38
|
|
User rating: 0
Joined: Mon 12 Jan, 2015, 16:12 Posts: 11 Location: United States, Virginia
|
Dear Amine, Thank you for your quick response and your help. Best regards, pedion
|
|
|
|
|
|
Pages: [
1
]
|
|
|
|
|