Did you recompile the indicator after unchecking "Calculate once per bar"? Just in case, please try deleting the .jfx file and then make sure "Calculate once per bar" is unchecked, then compile and plot it on chart.
CIAO wrote:
hope you fix this, thanks in advance
The pre-compile "Calculate once per bar" setting is there on purpose for performance reasons, normally this should be modifiable in run-time from indicator properties dialog "Recalculate on new candle only", which does not work that way at the moment (this will get fixed with future platform releases). In either case, at the moment please try the solution suggested above.